Replacement Form Roll Clutch/Bearing with Seals for use in Kompac IIs and IIIs which have 16MM form roll Shafts.

Keep one of these clutch-Bearings on hand and be prepared should a one-way clutch fail.

Note: This clutch-Bearing and seals 'must' be installed by 'pressing' into the form roller gear, 'Never Hammered'.

Always make sure that this replacement clutch is correctly oriented when pressed into gear, always orient it with its stamped letters facing the same direction as did original bearing/clutch.

If you do not have a bearing press, order one of our 16MM Clutch-Bearing Press Kits, part #PS16CBP.