| * Original Kompac Form, Metering, and Oscillator Rolls have a precisely designed hardness with ink an surface ground to an extremely fine and uniform finish. * Compounds used to create Kompac form rolls is of an extraordinarily high quality blend of rubber, which has a precise hardness range of between 56 and 62 Shore and with a precise surface finish that is critical for obtaining optimum dampening performance. * The Kompac form roll's surface finish grind must be no finer than 5 microns nor greater than 7 microns for optimum dampening performance. * The memory and diamensional stability of Kompac Form Rolls are extremely good, it is not uncommon to get 5 to 8 (and often more) years of service life from a Kompac form roll, the highest use-life of any dampener form roll in the industry! * Kompac Metering Rolls are machined of high quality Delrin, a high density Engineering Plastic with ultra smooth ceramic seal rings at each end for optimum seal use-life. * After market form rolls that are too soft or have too course a surface finish causes the Kompac to run too wet. * After market Metering Rolls with 'steel seal rings' cause premature Teflon Seal wear. * Accept no substitute for Kompac's Higher Quality Componet Parts and Rollers and then you can always expect optimum performance from the Kompac. *Note: If want to Rebuild your older Kompac and need new parts, send an email to attention Roger at 'Sales@Kompac.com' with a listing of parts needed for your Kompac model, and we will give you a discounted 'Kit Price' quote via email comprised of Genuine Kompac Parts. |
